Product Details:
Payment & Shipping Terms:
|
Application: | Pulling The UV Light | Diameter: | From DN250-1650 |
---|---|---|---|
Thickness: | 0.5mm | Length: | 100m |
Environment: | Environment Protection | Life: | 50 Years |
Highlight: | CIPP UV D919 |
The UV CIPP cure system light rack pulling the rope of high-temperature resistance
The reserved rope and the pull light rope shall be connected with a dead buckle to ensure that they will not fall off accidentally, and the nodes shall be wrapped with adhesive tape, especially the rope head of the pull light rope, which is easy to cause the inner membrane to be scratched during the dragging process. In the process of pulling the lamp rope down into the material with the reserved rope, it must be operated under the condition that the material is inflated, otherwise, it is easy to cause damage to the inner membrane.
The most common cause of inner membrane damage is the lighting process. I hope you must pay attention to it. Before lowering the lamp, check the lamp wheel, lamp body, and connecting wire for burrs and resins. If any, clean it and smooth the wheel. If it is a headlamp wheel, it is recommended to wipe a small amount of grease to reduce the friction of the material's inner membrane during headlamp lifting.
In the process of lowering the lamp, it is necessary to ensure that the material bulges up and the lamp enters the material smoothly without obstruction. If the lamp cannot enter the material smoothly, it is necessary to find out the cause of the obstruction. It is not allowed to drag or kick. Most of the inner membrane damage is caused at this time. I hope you will pay attention to pulling the lamp into the material as much as possible, leaving enough length for the binding head to facilitate operation, and avoiding hindering the lifting and lowering of the headlamp.
How | Pulling |
Application | Public sewers |
Length | 100m |
Contact Person: Aaron Wang
Tel: +8613641967601